1500W Band Heater for Premium Kettle

MSRP: $84.99
(You save $5.00 )
(12 reviews) Write a Review
Calculated at Checkout

Band heaters are a more efficient heating method than electric hotplates. They also reduce the risk of scorching by lowering the heat density and moving the heat from the bottom of the kettle, where particles will settle, to the sides of the kettle. The weight of a complete moonshine still is not an issue when using a band heater, unlike a hotplate, which can be crushed under the weight of a full kettle.

These band heaters are specifically made to fit Brewhaus 8 gallon and 15 gallon premium kettles. Because they wrap around the kettle, the diameter of the kettle must match the band heater precisely. We cannot guarantee that our band heaters will fit any type of kettle other than Brewhaus kettles.

Note: Band heaters are electric heating elements, and they will short out if you get them wet.


  • Made of stainless steel, matching the finish on your kettle
  • 110V
  • 1500W
  • 13.98" x 2.36" (355mm x 60mm)
  • Lower risk of scorching than an internal heating element


  • Always place your kettle on a heat tolerant surface when heating.
  • A 2" distillation column requires one band heater regardless of whether you are using an 8-gallon or 15-gallon kettle.
  • A 3" column with an 8 gallon kettle requires one band heater. A 3" column with a 15 gallon kettle may require 2 band heaters to bring it to a boil and then cut to one band heater during distillation.
  • A 4" column with a 15-gallon kettle may require 2 or 3 band heaters, depending on additional factors.

12 Reviews Hide Reviews Show Reviews

  • 4
    Works well

    Posted by Len on Oct 3rd 2015

    I love the design, the band heater is slow to boil 6gal in my 7gal PSII but there is no flame and no propane so its worth the long heatup time. The cord and plug are pretty cheap but its hung in there for dozens of uses now. I highly recommend electric heating.

  • 5
    Works well on my kettle

    Posted by Roger on Aug 2nd 2015

    I built a kettle out of a 15 gallon keg with an opening near the bottom as well as the top. This band works well as the keg is slightly larger than the band, so I had to have about a 4" gap which worked out great at the opening area. I got a piece of all-thread to replace the screw that was in there. The opening is a 6" ferrell with an end plate that I drilled and tapped for one of those 1500 watt immersion heaters, so between the two I have 3000 watts of power heating up the kettle. Works well. The only thing that I worry about is where the cord attaches to the band strip. Haven't had any trouble with it as of yet, but it is an area that I take care to protect, it just seems flimsy there. I should also state that I have just started and have only used this on 1 run.

  • 4
    Nice product but cord is very short

    Posted by Chris on May 30th 2014

    I just got this in last night and wanted to try it out on my premium kettle. I have to say that it did heat up faster than with my regular hot plate. My only suggestion would be to make a longer cord.